7.5 HP Single Phase Electric Motor 184t Frame Odp 3510 RPM 208-230 Volts Weg

BRAND NEW WEG 7.5 HORSEPOWER HIGH EFFICIENCY, HIGH PERFORMANCE NEMA PREMIUM ELECTRIC MOTOR. THIS MOTOR SITS ON A 184T FRAME AND SPINS 3510 RPM. 1 1/8 DIAMETER KEYED SHAFT, 208-230VOLT SINGLE PHASE. THIS 115 LB HEAVY DUTY INDUSTRIAL GRADE WEG MOTOR IS SPECIFICALLY DESIGNED TO WITHSTAND THE STARTING TORQUE THAT IS REQUIRED TO POWER INDUSTRIAL GRADE COMPRESSOR PUMPS.

THIS IS A CAPACITOR START AND RUN COMPRESSOR DUTY MOTOR WITH CAST IRON FRAME CONSTRUCTION. THIS MOTOR IS NOT MADE IN CHINA. PLEASE MAKE SURE THE INFORMATION FROM YOUR EXISTING MOTORS DATA PLATE MATCHES THE INFORMATION SHOWN BELOW. 7.5HP - 184T FRAME - 3510 RPM - 230V - SINGLE PHASE - ODP (OPEN DRIP PROOF) ENCLOSURE - REVERSIBLE ROTATION - CAST IRON FRAME.

WHY YOU ALWAYS NEED A MAGNETIC STARTER ON INDUSTRIAL GRADE ELECTRIC MOTORS FOR AIR COMPRESSORS. A MAGNETIC STARTER IS ALWAYS REQUIRED ON ANY 184T FRAME MOTOR AND LARGER. WIRING AN INDUSTRIAL SIZE MOTOR THROUGH THE PRESSURE SWITCH ALONE, IS NEVER A GOOD IDEA, AND HERE'S WHY. PRESSURE SWITCHES DO NOT COME WITH OVERLOAD PROTECTION FROM POWER SURGE OR LIGHTING.

IN ADDITION, PRESSURE SWITCHES HAVE VERY SMALL CONTACT POINTS THAT CONNECT TO THE MOTOR. SMALL CONTACT POINTS CAN STARVE YOUR MOTOR OF THE NECESSARY POWER IT REQUIRES TO START AND RUN NORMALLY. MAGNETIC STARTERS NOT ONLY PROVIDE YOU WITH MOTOR PROTECTION FROM POWER SURGE AND LIGHTING, THEY ALSO HAVE LARGER CONTACT POINTS THAT CONNECT TO YOUR ELECTRIC MOTOR. ALLOWING FOR A STEADY FLOW OF CURRENT THAT AN INDUSTRIAL GRADE MOTOR REQUIRES TO RUN AND ESPECIALLY START UP.

BY INCORPORATING A MAGNETIC STARTER WILL ALLOW YOUR MOTOR TO LAST MUCH MUCH LONGER. SHAFT: 1-1/8" SHAFT DIAMETER (2.75" TOTAL SHAFT LENGTH). (NOT RECOMMENDED ON VOLTAGES LESS THAN 208 VOLT). ROTATION: REVERSIBLE, CAN BE WIRED FOR BOTH CW OR CCW ROTATION.

ENCLOSURE TYPE: ODP (OPEN DRIP PROOF) ONLY RATED FOR INDOOR APPLICATIONS. RPM: 3510 (WILL REPLACE 3450, 3490, 3550 AND ANY OTHER RPM LESS THAN 5% OF 3600RPM). FRAME: 184T (ALSO REPLACES 182T FRAME). POWER FACTOR (100%): 0.95. DIMENSIONS: SEE ATTACHED PIC FOR BOLT DIMENSIONS AND MOTOR DIMENSIONS.

RECOMMENDED TO BE USED WITH A MAGNETIC MOTOR STARTER RATED MINIMUM 40AMPS. WE WILL GLADLY ASSIST YOU WITH YOUR APPLICATION QUESTIONS. We would be more than happy to correct any issue.

Regardless if we accidentally sent you the wrong item (which seldom happens) or the customer ordered the wrong part by mistake. WE WILL correct any potential problem.

Liability: UPE_Group is a dstributor and as such, has no direct or indirect control over the materials, processes, or quality control procedures used by the manufacturers of the products we resell. Accordingly, UPE_Group will NOT be held responsible for damages resulting from product defects, or, from mis-applications/improper installations by the customer or end user. It is the purchasers responsibility to determine the suitability of the product for the specific application. If it is deemed defective, UPE_Group shall be held harmless of any and all damages including (but not limited to) physical injury, property damage, water damage or otherwise for any reason. It is the purchasers responsiblity to determine the suitability of these products for your specific application.

Including, but not limited to, using alternative products. UPE_Group shall be held harmless of any and all damages including but not limited to physical, property, water or otherwise for any reason. Your use of any information or materials on this listing is entirely at your own risk, for which we shall not be liable. By submitting your order, the purchaser acknoledges agreement with the Terms & Conditions as outlined here and our website. The item "7.5 HP SINGLE PHASE ELECTRIC MOTOR 184T FRAME ODP 3510 RPM 208-230 VOLTS WEG" is in sale since Wednesday, May 24, 2017.

This item is in the category "Business & Industrial\Industrial Automation & Motion Controls\Electric Motors\Gearmotors". The seller is "upe_group" and is located in Marietta, Georgia. This item can be shipped to United States, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, China, Sweden, South Korea, Indonesia, Taiwan, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Bahamas, Israel, Mexico, New Zealand, Philippines, Singapore, Switzerland, Norway, Saudi arabia, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Costa rica, Panama, Trinidad and tobago, Guatemala, Honduras, Jamaica, Aruba, Belize, Dominica, Grenada, Saint kitts and nevis, Turks and caicos islands, Bangladesh, Brunei darussalam, Bolivia, Ecuador, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Liechtenstein, Luxembourg, Monaco, Macao, Martinique, Nicaragua, Peru, Pakistan, Paraguay, Viet nam, Uruguay, Canada, South africa, Colombia, Antigua and barbuda, Saint lucia, Barbados, Bermuda, Cayman islands, Maldives, Oman, Reunion, Sri lanka, Montserrat.

Enclosure Type: ODP (Open Drip-Proof)
Insulation Class: F (Max 311°F)
Model: 00736OS1C184T
Country/Region of Manufacture: Brazil
MPN: 00736OS1C184T
Rated/Full-Load Torque: 11.1 FT LBS
Shaft Diameter: 1 1/8
Starting/Locked Rotor Torque: 240%
Full Load Amps: 33.4 @ 208V / 29.6 @ 230V
Rated Load (HP): 7 1/2
Current Type: AC
Special Motor Construction: COMPRESSOR DUTY
Brand: WEG
Nominal Rated Input Voltage: 230 V
California Prop 65 Warning: WARNING: Some parts of the product contains chemicals including Cobalt, known to the state of California to cause cancer, birth defects or other reproductive harm.
Reversible/Non-Reversible: Reversible
Actual Rated Input Voltage: 208-230
DIRECT REPLACEMENT OF: LEESON 132044 132044.00 BALDOR 753450
AC Phase: Single Phase
ADDITIONAL RPM'S THIS MOTOR WILL REPLACE: 3440 3450 3470 3490 3500 3520 3540 3500 3600
Base RPM: 3510